Drive features: front engine rear-wheel drive (or all-wheel drive) on the car Steyr shaft, as the car in motion the process of deformation of the suspension, main gear shaft and the transmission input shaft (or transfer case) between the output shaft is often relative motion, in addition, to effectively avoid certain mechanism or device (not achieve straight pass), there must be a means to achieve normal power transmission shaft Hebei Steyr, so it was a universal joint drive. Gimbal drive must have the following characteristics: a, to ensure the relative position of the two shafts connected to the range when the expected change in power can be reliably transmitted; b, ensure that the operation of connecting the two axes uniformly. Due to the additional load arising gimbal angle, vibration and noise should be within the allowable range; c, higher transmission efficiency, long life shaft Steyr company, simple structure, easy manufacture, easy maintenance. Car, since a universal joint cross shaft to the input shaft to the output shaft (a certain angle) is constant rotation, this must double universal joint (or joint) in the transmission, and the arrangement of the fork with two universal joints connected to the drive shaft in the same plane, and that section is equal to the angle between twenty. This point is very important. Should be designed to minimize the angle universal joints. Universal joint shaft assembly from the outside (RF section), the universal joint (VL section) and the spline shaft composition, RF section and VL section are CV type CVJ. VL drive shaft section with a flange bolt and is connected to the differential, RF sections are connected by a spline shaft and the front end portion of the alien wheel, left and right front wheels of a constant velocity universal joint transmission shaft . Installation (1) Tighten the oil and the spline shaft on the net, and coated with lithium grease. (2) Apply the repellant around 5mm D6 Steyr factory on the outer drive shaft universal joint (RF section) of the spline, and then loaded on the drive shaft spline sets. After the shaft after installation repellant coating should stop 60min, before you can use the car. (3) Reassemble the ball stud in the original position, and tighten the nut. When installing ball stud, can not damage the bellows jacket. (4) Check the camber when necessary. (5) the wheels touch the ground, tighten the wheel fixing nut. Shengxing auto parts, drive shaft manufacturers] [Steyr, Steyr shaft is provided by shengxing Auto Parts. Search for "car clutch plate pressure plate, V-thrust rods, thrust rod, drive shaft, drive shaft hanger" fly suppliers, network operators choose to have the whole alliance certification: Hebei Shengxing Auto Parts Co., Ltd. (www . hjshengxing.com), trustworthiness and reliability, now click on the "Business League Support" on page live chat with us now!